Directions

APPLICATION:

1. Strip floors to remove old waxes, sealers and finishes.
2. Rinse thoroughly and let dry.
3. With clean equipment apply thin, even coats of Eccothane.
4. Under normal conditions, allow to dry for 30 minutes between coats.
5. For best results, apply a maximum of 4 coats in 24 hours.

NOTE: For stripping and maintaining asbestos containing tile, follow OSHA or EPA guidelines.

COVERAGE: One gallon covers up to 3,000 square feet (1 liter covers 75 m2).

MAINTENANCE:

Daily:

1. Sweep or dust mop frequently to remove gritty soil.
2. Use our neutral cleaner to damp mop spills as they occur. Damp mop or auto scrub nightly with neutral cleaner.
3. Buff if desired with high speed equipment and soft ultra high speed pads.

Weekly:

1. To repair and deep clean floor, apply our restorer with mop or auto scrubber.
2. Allow floor to dry.
3. Burnish floor with high speed equipment. This finish also responds to spray buffing with conventional speed equipment.

NOTE: Always dust mop after burnishing or spray buffing.

Periodic Recoating:

1. Dust mop entire floor then scrub aggressively using our cleaner/restorer and auto scrubber with a red or green pad.
2. Use a blue pad for heavily marked or unusually dirty floor.
3. Rinse floor and allow to dry.
4. Apply Eccothane.

Read label before use. Keep out of the reach of children. If medical advice is needed, have product container or label at hand.

See label directions and SDS for complete usage and safety instructions.