Directions

Application:

1. Strip floors to remove old waxes, sealers and finishes.
2. Rinse thoroughly and let dry.
3. For best results, use a flat mop to apply thin, even coats of finish.
4. Under normal conditions (50% humidity and 70°F), allow to dry for 20-30 minutes between coats.
5. For best results, apply a maximum of 4 coats in 24 hours.

NOTE: For stripping and maintaining asbestos containing tile, follow OSHA or EPA guidelines.
COVERAGE: One gallon covers up to 3,000 square feet (1 liter covers 75 m²).

Maintenance:

1. Daily: Sweep or dust mop as necessary to remove gritty soil.
2. Dirty Floors: Clean floor with a recommended cleaner, according to label directions. Rinse, if necessary, and let dry.
3.  Traffic Area: Clean floor with a recommended cleaner, according to label directions. Rinse, if necessary, and let dry. Apply additional thin coats of floor finish to traffic lanes as needed.
4. Buffing: If desired, periodic burnishing with blended hair pads will enhance appearance.
5. Periodic Complete Maintenance: When stripping is required, use recommended stripper, following label directions for best results.

Read label before use. Keep out of the reach of children. If medical advice is needed, have product container or label at hand.

See label directions and SDS for complete usage and safety instructions.­­