Directions

APPLICATION:

1. Strip floors to remove old waxes, sealers and finishes.
2. Rinse thoroughly and let dry.
3. With clean equipment apply thin, even coats of G2 Green Finish Gen 2.
4. Under normal conditions, allow to dry for 20 minutes between coats.
5. For best results, apply a maximum of 4 coats in 24 hours.
6. Allow 48 hours for the finish to reach full cure before wet cleaning. Burnishing will speed cure time.

NOTE: For stripping and maintaining asbestos containing tile, follow OSHA or EPA guidelines.
COVERAGE: One gallon covers up to 3,000 square feet (1 liter covers 75 m²).

MAINTENANCE:

Daily:

1. Sweep or dust mop frequently to remove gritty soil.
2. Use our Green Clean (8513FC) to damp mop spills as they occur. Damp mop or auto scrub nightly with Green Clean.
3. Buff if desired with high speed equipment and blended hair pads.

Weekly: 

1. To repair and deep clean floor, apply a green restorer with mop or auto scrubber.
2. Allow floor to dry.
3. Burnish floor with high speed equipment. This finish also responds to spray buffing with conventional speed equipment. NOTE: Always dust mop after burnishing or spray buffing.

Periodic Recoating:

1. Dust mop entire floor then scrub aggressively using a green restorer and auto scrubber with a red or green pad.
2. Rinse floor and allow to dry.
3. Apply G2 Green Finish Gen 2.

Stripping G2 Green Finish Gen 2:

1. Strip with Green Strip (8881FX) diluted 1:4.

See label directions and SDS for complete usage and safety instructions.